Tech Note Library
List to TN docs
Tools required: Small Flat head screw driver 2.5mm Hex wrench or ball driver. Before beginning this procedure, please ensure that the filam...
Mon, 29 Oct, 2018 at 1:39 PM
Cold Pull Procedure to Unclog Nozzle Begin this procedure with a cold print head, the motors turned-off, and the filament loaded. First, disconnect...
Wed, 6 Dec, 2017 at 12:59 PM
KISSlicer Setup and Use
Introduction
This guide shows how to use KISSlicer with a DeltaMaker 3D Printer. This document is created with the beginne...
Mon, 24 Aug, 2015 at 4:14 PM
DeltaMaker SD Card Reflash Procedure You'll need some things in order to complete this procedure: 2.5mm hex wrench Micro SD Card Adapter ...
Thu, 11 Apr, 2024 at 10:32 PM
DeltaMaker SD Card Installation Procedure
To complete this procedure, you will need a 2.5mm hex wrench.
You may leave th...
Mon, 24 Aug, 2015 at 4:05 PM
To complete this procedure, you will need:
2.5mm hex wrench, and
Replacement microSD card
If your DeltaMaker has a Raspberry Pi 2 or 3 v...
Thu, 13 Apr, 2017 at 11:48 AM
Exporting an STL file from Solidworks in the correct orientation
After modeling your part, click on Reference Geometry under the Features...
Mon, 5 Oct, 2015 at 12:18 PM
DeltaMaker USB Software Update
You'll need the following things to complete this procedure:
2.5mm hex wrench
Etcher: http://www.etch...
Mon, 9 Oct, 2017 at 12:10 PM
How to enable your webcam on the DeltaMaker
You'll need some things in order to complete this procedure:
2.5mm hex wrench
While yo...
Wed, 21 Feb, 2018 at 1:17 PM